![]() ![]() Pass the furling line through the opening in the side of the cup, then up through the hole in the top of the furling drum flange. Slide the furling drum down the luff, into the cup and over the main bearing. If the forestay needs to be adjusted, remove the luff support pin and slide up the furling drum to expose turnbuckle. You can push the washer up into the cavity of the furling drum again. You may knock the thrust washer (part M on page 2) out of place doing this. ![]() If the mast is up, pass a light line through the luff and make it fast to the cotter pin hole in the swage-end of the turnbuckle using a piece of wire to make the link. If so, use a cigarette lighter and melt a piece of 18 line to the OTHER end of the halyard (see instruction 2 on previous page). After this time, carefully cut the tape and check the straightness. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |